Temperature Door Actuator
The temperature actuator and auxiliary temperature actuator are a 3 wire bi-directional electric motor. Ignition 3 voltage, ground and control circuits enable the actuator to operate. The control circuit uses a zero to 12 volt linear-ramped signal to command the actuator movement. The zero to 12 volt control values represent the opposite limits of the actuator range of motion. The values in between zero and 12 volts correspond to the positions between the limits. When the HVAC control assembly sets a commanded, or targeted, value, the control signal is set to a value between zero and 12 volts. The actuator shaft rotates until the commanded position is reached. The module will maintain the control value until a new commanded value is needed.