Washer Hose Repair and Routing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The washer hose can be a component within the main body wire harness conduit. The washer hose is a hard plastic convoluted tube that could be wrapped with electrical tape along the main body electrical wiring harness. It starts underhood where it connects to the washer solvent container jumper hose. The washer hose usually routes into the main body wire harness underhood and passes through the front of the dash panel grommet. The washer hose is routed either inside the vehicle interior behind the left front side window garnish molding, along the floor pan area and continues to the rear of the vehicle, as equipped. The washer hose could be routed back to the center of the vehicle where it could possibly connect to the high mounted stop lamp or the rear window washer pump where it connects by rubber flexible tubing, at the lift gate opening, if equipped.