Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Position the driver side air inlet grille panel (2) to the plenum area.
- Secure the windshield washer hose to the bottom side of the air inlet grille panel.
- Install the driver side air inlet grille panel (2) to the vehicle.
- Position the panel behind the hood hinge and over the wiper transmission pivot shafts.
- Connect the windshield washer hose (1) to the windshield washer nozzle.
- Align the holes in the air inlet grille to the holes in the plenum.
- Install the retainers (1), push the centers of the retainers inward to secure.
- Position the passenger side air inlet grille panel (2) to the plenum area.
- Secure the windshield washer hose to the plenum and to the washer nozzle (1).
- Position the panel around the hood hinge and ensure the tabs on the backside of the panel are located under the bottom edge of the windshield.
- Align the holes in the air inlet grille panel to the holes in the upper plenum.
- Install the 5 retainers.
- Push the center of the retainers inward to secure.
- Apply the hood rear corner seal assembly to the air inlet panel, apply adhesive if needed to secure.
- Secure the 9 retaining clips inside the sealing strip to the air inlet grille panel.