Circuit/System Verification
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the following DTCs are not set: U1814, B1428.
- If either of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- With a scan tool, access Body Control Module, Power Mode data display list and compare all parameters listed with the corresponding ignition key position. The PMM Power Mode Parameters table below illustrates the correct state of these input parameters (circuits) in correspondence to the ignition switch position.
PMM Power Mode Parameters
| Ignition Switch Position | Current Power Mode | Ignition Off/Run/Crank (Off/Run Crank Voltage Circuit) |
Ignition Accessory/Run (Accessory Voltage Circuit) |
Ignition Run/Crank (Ignition 1 Voltage Circuit) |
|---|---|---|---|---|
| Off Key Out | Off | Key Out/ACC | Inactive | Inactive |
| Off Key IN | Off | Key In/Off | Inactive | Inactive |
| Accessory | Accessory | Key Out/ACC | Active | Inactive |
| Run | Run | Run | Active | Active |
| Start | Crank Request | Crank | Inactive | Active |