LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1935 (Wiring Systems And Power Management - Service, Troubleshooting & Diagnosis) >> Delphi Connectors (Pull To Seat) >> Terminal Installation

Terminal Installation

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the terminal and pull the wire from the back of the connector in order to seat the terminal.
  2. If necessary, cut the new wire to proper length and splice with existing circuit. Refer to Splicing Copper Wire Using Splice Sleeves .
  3. If the connector is outside of the passenger compartment, apply dielectric grease to the connector.
  4. Install the TPA, CPA, and/or the secondary locks.
scientia non olet · About LEMON Manuals