LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1933 (Hybrid Engine Electrical System 3.6L (Hp5)) >> Diagnostic Information and Procedures >> DTC P0AFA >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that no hybrid powertrain control module (HPCM) or engine control module (ECM) DTCs are set that indicate generator, HPCM, or battery failure, or that disable the high voltage.
  2. Engine cranking, observe the scan tool accessory DC power control module (APM) HPCM 300V Circuit parameter. The reading should be between 225 V and 380 V.
    • If not within the specified range, refer to Jump Assist .
  3. Ignition ON, observe the scan tool ACCM High Battery Voltage parameter. The reading should be between 225 V and 380 V.
scientia non olet · About LEMON Manuals