LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1932 (Hybrid Energy Storage System - 3.6L (Hp5)) >> Repair Instructions >> Drive Motor Battery Disconnect Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Module Fasteners, Connectors And Drive Motor Battery Disconnect Control Module
    GM2183242Courtesy of GENERAL MOTORS CORP.
  1. Install the drive motor battery disconnect control module (3).
  2. Connect the electrical connectors (2).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the module fasteners (1) and tighten to 9 N.m (80 lb in).
    4. Fig 2: Battery Terminal Cables
    GM2183181Courtesy of GENERAL MOTORS CORP.
  4. Remove the EL-48569:  covers from the terminals (1).
    5. Fig 3: Terminal Fasteners
    GM2183128Courtesy of GENERAL MOTORS CORP.
  5. Remove the EL-48569:  covers, one at a time, from the 300 Volt positive and negative terminals.
  6. One at a time, reposition the cable terminals and install the terminal fasteners (1) and tighten to 9 N.m (80 lb in).
    7. Fig 4: Plastic Terminal Covers
    GM2183070Courtesy of GENERAL MOTORS CORP.
  7. Install the plastic terminal covers (1).
    8. Fig 5: Center Cover
    GM2183068Courtesy of GENERAL MOTORS CORP.
  8. Install the battery center cover fasteners (1) and the center cover (2).
  9. Install the drive motor generator control module. Refer to Drive Motor Generator Battery Control Module Replacement .
  10. Enable the high voltage system. Refer to High Voltage Enabling .
  11. If replacing, reprogram the module. Refer to Control Module References .
scientia non olet · About LEMON Manuals