Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Catalytic Converter To Muffler Nuts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the right catalytic converter nuts (1) to rear muffler .Tighten to 60 N.m (44 lb ft).

Fig 2: Left Catalytic Converter Bolts

Courtesy of GENERAL MOTORS CORP.

Install the lower left catalytic converter to the right catalytic converter.Tighten to 46 N.m (34 lb ft)

Fig 3: Left Side Exhaust Manifold Heat Shield Bolts

Courtesy of GENERAL MOTORS CORP.

Lower the vehicle.
Install the left side catalytic converter to exhaust manifold nuts (1) and tighten to 35 N.m (26 lb ft).

Fig 4: Left Side Exhaust Manifold Heat Shield Bolts

Courtesy of GENERAL MOTORS CORP.

Install the exhaust manifold heat shield.
Install the left side exhaust manifold heat shield bolts (1) and tighten to 10 N.m (89 lb in).

Fig 5: Oxygen Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the oxygen sensor electrical connector (1) and tighten to.
Install the HO2S sensor. Refer to Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 .