LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Automatic Transaxle Servicing) >> Removal & Installation >> Detent Lever & Roller Assembly >> Removal

Detent Lever & Roller Assembly: Removal

WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the scavenge screens. See DRAINING & REFILLING  under LUBRICATION. Remove the lower controls and valve assembly. See LOWER CONTROL VALVE BODY ASSEMBLY  . Using a pair of pliers, grasp the detent roller end of the detent spring (27). See Fig 1 . Remove the detent spring (27).
  2. Remove the 13-mm detent roller bolt pivot arm, the sleeve, and the washer (26). Remove the 15-mm manual shaft nut (18).
  3. You must hold the detent lever (17) in place when removing the manual shaft nut (18) in order to prevent damage to the actuator rod (21). Remove the detent lever (17) and the actuator rod (21).
Fig 1: Exploded View Of Detent Lever & Roller
G00094546Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals