LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1929 (Engine Mechanical - 3.6L (2 Of 6)) >> Repair Instructions - On Vehicle (1 Of 2) >> Camshaft Cover Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Camshaft Cover Bolt Grommets
    GM1306486Courtesy of GENERAL MOTORS CORP.
  1. Install new camshaft cover bolt grommets prior to installing the camshaft cover bolts.
    2. Fig 2: Locating Engine Front Cover Split Lines
    GM1306487Courtesy of GENERAL MOTORS CORP.
  2. Place a bead 8 mm (0.3150 in) in diameter by 4 mm (0.1575 in) in height of RTV sealant, GM P/N 12378521 (Canadian P/N 88901148) or equivalent, on the engine front cover split lines (1).
    3. Fig 3: Aligning Left Camshaft Cover On Left Cylinder Head
    GM1306488Courtesy of GENERAL MOTORS CORP.
  3. Place the left camshaft cover into position onto the left cylinder head.
    4. Fig 4: Identifying Left Camshaft Cover Bolts
    GM1306489Courtesy of GENERAL MOTORS CORP.
  4. Loosely install the left camshaft cover bolts.
    5. Fig 5: Tightening Sequence For Left Camshaft Cover Bolts
    GM1392433Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution
  5. Tighten the left camshaft cover bolts in the sequence shown to 10 N.m (89 lb in).
    6. Fig 6: Identifying Special Tool - EN 46101
    GM1306490Courtesy of GENERAL MOTORS CORP.
  6. Remove the EN 46101  . See Special Tools .
  7. Install NEW spark plugs into the left cylinder head. Refer to Spark Plug Replacement
scientia non olet · About LEMON Manuals