LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1928 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill Without HP5) or Cooling System Draining and Filling (GE 47716 Fill Without HP5) .
  2. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  3. Remove catalytic converter - left side. refer to Catalytic Converter Replacement - Left Side (LZ4) .
  4. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  5. Remove air conditioning compressor. Refer to Air Conditioning Compressor Replacement (LZ4) .
  6. Remove the crankshaft position actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement .
  7. Remove the thermostat housing.
  8. Remove the water pump. Refer to Water Pump Replacement (LZ4) .
  9. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement .
  10. Remove the oil pan. Refer to Oil Pan Replacement .
    11. Fig 1: Identifying Engine Front Cover, Bolts & Gasket
    GM1557694Courtesy of GENERAL MOTORS CORP.
  11. Remove the engine front cover bolts.
  12. Remove the engine front cover.
  13. Remove the engine front cover gasket.
  14. Clean and transfer any parts as needed.
scientia non olet · About LEMON Manuals