LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1928 (Engine Mechanical - 3.5L) >> Repair Instructions - On Vehicle >> Camshaft Position Actuator Magnet Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Camshaft Position Actuator Magnet & Bolts
    GM1557696Courtesy of GENERAL MOTORS CORP.
  1. Install the camshaft position actuator magnet O-ring seal and magnet.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the camshaft position actuator magnet bolts and tighten to 10 N.m (89 lb in).
    3. Fig 2: Locating Camshaft Position Actuator Magnet Electrical Connector
    GM1611455Courtesy of GENERAL MOTORS CORP.
  3. Connect the camshaft position actuator magnet electrical connector (2).
  4. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals