LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1928 (Engine Mechanical - 3.5L) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Removal - Right Side

Valve Rocker Arm Cover Removal - Right Side

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Ignition Coil Assembly, Studs & Nuts
    GM1557662Courtesy of GENERAL MOTORS CORP.
  1. Remove any remaining spark plug wires from their retainers.
  2. Remove the ignition coil assembly bolts and nuts.
  3. Remove the ignition coil assembly.
  4. Remove the ignition coil assembly studs, if necessary.
    5. Fig 2: Identifying Fresh Air Tube
    GM1557664Courtesy of GENERAL MOTORS CORP.
  5. Remove the fresh air tube from the valve rocker arm cover.
    6. Fig 3: View Of Right Valve Rocker Arm Cover
    GM1557668Courtesy of GENERAL MOTORS CORP.
  6. Remove the valve rocker arm cover bolts.
    7. IMPORTANT: When removing the valve rocker arm cover make sure the gasket stays in place attached to the cylinder head.
  7. Remove the valve rocker arm cover.
  8. Cut the room temperature vulcanizing (RTV) in the channel where the intake, cylinder head and valve rocker arm cover meet with a suitable tool.
  9. Remove and discard the valve rocker arm cover gasket, valve rocker arm cover grommets and valve rocker arm cover bolts if they are serviced with the grommet.
scientia non olet · About LEMON Manuals