Cylinder Head Assemble

Special Tools

• EN-47823:  Valve Spring Compressor Adapter
• J 5892-D:  Valve Spring Compressor

For equivalent regional tools, refer to Tools and Equipment .

Fig 1: Identifying Valve Components
Courtesy of GENERAL MOTORS CORP.
NOTE: Use oversize valve stem seals if you install oversize valves.
1. Lubricate the valve stem with clean engine oil.
2. Install the valves.
3. Lightly tap the new or reconditioned valves into the valve seat.
4. Install the valve stem oil seals, ensuring proper intake - black seal and exhaust - brown seal, seals are installed.
5. Install the valve springs.
6. Install the valve spring caps.
Fig 2: Compressing Valve Spring
Courtesy of GENERAL MOTORS CORP.
7. Using caution so as not to damage the valve spring or valve spring dampener, compress the valve springs using the J 5892-D:  compressor (1) and the EN-47823:  adapter (2).
8. Install the valve spring cap keys. Hold the valves in place with grease, if necessary.
9. Release the valve springs.
10. Ensure that the valve locks are seated.
Fig 3: View Of Heater Inlet Pipe Stud & Coolant Temperature Sensor
Courtesy of GENERAL MOTORS CORP.
11. Apply sealer P/N 21485278 to the coolant temperature sensor.
CAUTION: Refer to Fastener Caution .
12. Install the coolant temperature sensor, if required. Tighten the coolant temperature sensor to 23 N.m (17 lb ft).
13. Install the heater inlet pipe stud, if required. Tighten the heater inlet pipe stud to 35 N.m (26 lb ft).