LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1928 (Engine Mechanical - 3.5L) >> Repair Instructions - Off Vehicle >> Camshaft Installation

Camshaft Installation

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Camshaft & Camshaft Sprocket Bolt
    GM1682175Courtesy of GENERAL MOTORS CORP.
  1. Coat the camshaft journals with clean engine oil.
  2. Coat the camshaft lobes with prelube GM P/N 12345501 (Canadian P/N 992704) or the equivalent.
  3. Install the camshaft using the following procedure:
    1. Install a camshaft sprocket bolt into the camshaft. Tighten finger tight only.
    2. Carefully rotate the camshaft while installing the camshaft into the camshaft bearings.
    4. Fig 2: View Of Camshaft Thrust Plate
    GM54981Courtesy of GENERAL MOTORS CORP.
  4. Install the camshaft thrust plate.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the camshaft thrust plate screws and tighten to 10 N.m (89 lb in).
    6. Fig 3: View Of Camshaft Position Sensor
    GM909619Courtesy of GENERAL MOTORS CORP.
  6. Install the camshaft position sensor.
  7. Install the camshaft position sensor bolt and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals