LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1926 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (LY7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front tire/wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  2. Place drain pans under the vehicle as needed.
  3. Remove as much fluid from the remote power steering fluid reservoir as possible.
    4. Fig 1: Identifying Power Steering Gear Inlet Hose Fitting & Power Steering Pump
    GM1819151Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the power steering gear inlet hose fitting (1) from the power steering pump.
    5. Fig 2: Identifying Power Steering Gear Inlet Hose Fitting & Steering Gear
    GM1819198Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the power steering gear inlet hose fitting (1) from the steering gear.
  6. Remove the power steering gear inlet hose from the vehicle.
scientia non olet · About LEMON Manuals