LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1926 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering gear inlet hose to the vehicle.
    2. Fig 1: Identifying Power Steering Gear Inlet Hose Fitting & Steering Gear
    GM1819198Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: Hand tighten the power steering gear inlet hose fittings before finalizing the torques.
  2. Connect the power steering gear inlet hose fitting (1) to the steering gear and tighten the fitting to 25 N.m (18 lb ft).
    3. Fig 2: Identifying Power Steering Gear Inlet Hose Fitting & Power Steering Pump
    GM1819151Courtesy of GENERAL MOTORS CORP.
  3. Connect the power steering gear inlet hose fitting (1) to the power steering pump and tighten the fitting to 25 N.m (18 lb ft).
  4. Clean any excess fluid from the vehicle and remove the drain pans.
  5. Install the front tire/wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals