LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1926 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Reservoir Replacement (LZ4) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering pump. Refer to Power Steering Pump Replacement (LY7)  or Power Steering Pump Replacement (LZ4)  or Power Steering Pump Replacement (LE5) .
    2. Fig 1: Removing Power Steering Reservoir (CB Series)
    GM482358Courtesy of GENERAL MOTORS CORP.
  2. Place the power steering pump assembly (1) on a fixed, flat surface, with the power steering pump shaft facing upward.
  3. Insert a screwdriver into the power steering fluid reservoir retaining clip tab (3) and bend it outwards.
  4. Slide the power steering fluid reservoir clip (4) away from the power steering fluid pump assembly (1).
  5. Repeat the above steps to remove the other power steering fluid reservoir clip (4).
  6. Remove the power steering fluid reservoir (2) from the power steering pump (1).
  7. Remove the O-ring seal from the neck of the power steering fluid reservoir (2) or inside the power steering pump housing (1). Discard the O-ring seal.
scientia non olet · About LEMON Manuals