LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1925 (Front Suspension System) >> Repair Instructions >> Front Wheel Bearing and Hub Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wheel Bearing/Hub
    GM1843952Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel bearing/hub assembly to the steering knuckle.
  2. Clean the threads of the bolts with the proper cleaner.
    3. NOTE: Allow the threadlocker to set for 10 minutes before using.
  3. Apply threadlocker GM P/N 89021297 (Canadian P/N 10953488) on 2/3 of the bolts threads.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the wheel bearing/hub mounting bolts and tighten to 130 N.m (96 lb ft).
    5. Fig 2: View Of Front Wheel Drive Shaft Spindle Nut
    GM1844090Courtesy of GENERAL MOTORS CORP.
  5. Install the wheel drive shaft spindle nut and tighten to 205 N.m (151 lb ft).
    6. Fig 3: View Of Wheel Speed Sensor Electrical Connector & Connector Bracket
    GM931451Courtesy of GENERAL MOTORS CORP.
  6. Install the wheel speed sensor electrical connector to the mounting bracket, if equipped.
    7. Fig 4: View Of Front Wheel Speed Sensor
    GM926677Courtesy of GENERAL MOTORS CORP.
  7. Connect the wheel speed sensor electrical connector.
  8. Install the speed sensor. Refer to Front Wheel Speed Sensor Replacement .
    9. Fig 5: View Of Front Brake Rotor
    GM931367Courtesy of GENERAL MOTORS CORP.
  9. Install the front brake rotor. Refer to Front Brake Rotor Replacement .
scientia non olet · About LEMON Manuals