LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1923 (Engine Mechanical - 2.4L) >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement (LAT) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Oil Level Indicator Tube
    GM1647397Courtesy of GENERAL MOTORS CORP.
  1. Install NEW oil level indicator tube O-ring seals, if necessary.
  2. Install the oil level indicator tube.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the oil level indicator tube bolt and tighten to 10 N.m (89 lb in).
  4. Raise and support the vehicle.
    5. Fig 2: View Of Starter And Engine Electrical Connectors
    GM1809558Courtesy of GENERAL MOTORS CORP.
  5. Install the knock sensor electrical connector lead (4) to the oil level indicator tube bracket.
    6. Fig 3: Identifying Engine Electrical Connectors Left Side
    GM1810743Courtesy of GENERAL MOTORS CORP.
  6. Install the engine wiring harness clip (3) to the oil level indicator tube bracket.
  7. Lower the vehicle.
    8. Fig 4: Oil Level Indicator
    GM1571745Courtesy of GENERAL MOTORS CORP.
  8. Install the oil level indicator.
  9. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About LEMON Manuals