LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1923 (Engine Mechanical - 2.4L) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement (LE5) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount Bolts
    GM1623160Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement (LE5) .
  2. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement (LE5) .
  3. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  4. Install the engine support fixture. Refer to Engine Support Fixture .
  5. Remove the engine mount to bracket bolts.
    6. Fig 2: Engine Mount To Side Rail Nuts
    GM1623161Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine mount to side rail nuts.
  7. Remove the engine mount from the engine compartment.
    8. Fig 3: Engine Mount Bracket
    GM1623162Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine mount bracket to engine bolts.
  9. Remove the engine mount bracket.
    10. Fig 4: Engine Front Cover
    GM1578293Courtesy of GENERAL MOTORS CORP.
  10. Remove the engine front cover to water pump bolt.
    11. Fig 5: Engine Front Cover Bolts
    GM1578292Courtesy of GENERAL MOTORS CORP.
  11. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  12. Remove the engine front cover bolts.
  13. Remove the engine front cover.
    14. Fig 6: Engine Front Cover Gasket
    GM1578294Courtesy of GENERAL MOTORS CORP.
  14. Remove and discard the engine front cover gasket.
scientia non olet · About LEMON Manuals