LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1923 (Engine Mechanical - 2.4L) >> Repair Instructions - Off Vehicle >> Piston and Connecting Rod Disassemble >> Disassemble

Piston and Connecting Rod Disassemble: Disassemble

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Piston Rings
    GM2146346Courtesy of GENERAL MOTORS CORP.
    WARNING: Handle the piston carefully. Worn piston rings are sharp and may cause bodily injury.
  1. Disassemble the piston rings (1, 2, 3, 4, 5). Use a suitable tool to expand the rings. The piston rings must not be reused.
    2. Fig 2: Identifying Piston Pin Retainer
    GM2148518Courtesy of GENERAL MOTORS CORP.
    NOTE: Two retainers hold the piston pins in place. No special tools are required to remove the piston pins. Ensure that the piston pin is not damaged. Do not reuse the retainers.
  2. Remove the piston pin retainers using the EN-46745:  remover (1).
    3. Fig 3: Identifying Piston Pin, Connecting Rod & Piston
    GM2148520Courtesy of GENERAL MOTORS CORP.
  3. Remove the piston pin (1) and the connecting rod (3) from the piston (2).
scientia non olet · About LEMON Manuals