Oil Pan Installation

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Applying Sealer To Oil Pan

Courtesy of GENERAL MOTORS CORP.

NOTE:

The lower crankcase surface must be free of contamination prior to applying the sealer.
Install and align the oil pan to block within 20 minutes of applying the sealer.
The oil pan must be fastened to final torque specification within 60 minutes of applying the sealer.

Apply a 2.25 mm bead of sealer (1) on the level part of the flange next to the chamfer around the perimeter of the oil pan and the oil suction port opening. Refer to Adhesives, Fluids, Lubricants, and Sealers .

Fig 2: View Of Oil Pan

Courtesy of GENERAL MOTORS CORP.

Install the oil pan.

Fig 3: Identifying Oil Pan Bolts Removal & Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the oil pan bolts and tighten to 25 N.m (18 lb ft) in sequence.