Crankshaft Balancer Installation

Special Tools

• EN-48585:  Crankshaft Balancer Guide
• EN-48953:  Camshaft Actuator Locking Tool
• J 38112-A:  Crankshaft Balancer Holder
• J 45059:  Angle Meter

For equivalent regional tools, refer to Special Tools .

Fig 1: Crankshaft Balancer Assembly
Courtesy of GENERAL MOTORS CORP.
CAUTION: Ensure both components are aligned correctly or serious engine damage will occur.
1. Install the J 38112-A:  holder into the end of the crankshaft.
2. Install the balancer onto the EN-48585:  guide. Use care to properly align the keyway and flats on the balancer with the oil pump drive.
Fig 2: Preventing Crankshaft Rotation Using Special Tool
Courtesy of GENERAL MOTORS CORP.
3. Install the J 38122-A:  holder.
CAUTION: Refer to Fastener Caution .
NOTE: Always install a new crankshaft balancer retaining bolt and washer.
4. Install a new retaining bolt and washer. Use the J 38122-A:  holder and a breaker bar to prevent the crankshaft from rotating when tightening the bolt. Tighten the bolt to 100 N.m (74 lb ft) plus 125 degrees using the J 45059:  meter.
Fig 3: Identifying Locking Tool
Courtesy of GENERAL MOTORS CORP.
5. Install the EN-48953:  locking tool (1) and tighten the bolts into the cylinder head. Tighten the EN-48953:  locking tool retaining bolts to 10 N.m (89 lb in).
6. Release the timing chain tensioner by applying 45 N.m (33 lb ft) counterclockwise torque to the crankshaft balancer bolt.
7. Remove the EN-48953:  locking tool.