Component Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the driver door latch assembly.
- With the switch in the open position, test for infinite resistance between the signal terminal 6 and the ground terminal 8.
- If not the specified value, replace the driver door latch assembly.
- With the switch in the closed position, test for less than 1.0 ohm between the signal terminal 6 and the ground terminal 8.
- If not the specified value, replace the driver door latch assembly.