LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Automatic Transaxle Servicing) >> Removal & Installation >> Accumulator & 2-1 Manual Servo >> Installation

Accumulator & 2-1 Manual Servo: Installation

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. If disassembled, assemble the 2-1 band servo. See appropriate OVERHAUL article. Install the manual 2-1 band servo. See Figure . Install the lube oil pipe to the front differential carrier internal gear lube hole. See Figure . Position the manual 2-1 band servo cover and accumulator into place.
  2. Install the manual 2-1 band servo cover bolts. Tighten the manual 2-1 band servo cover bolts to specification. Install the accumulator attaching bolts. Tighten the accumulator attaching bolts to specification. See TORQUE SPECIFICATIONS  .
  3. If removed, install the new filter seal. Install the filter. Install the oil pan. See DRAINING & REFILLING  under LUBRICATION. Lower the vehicle. Fill transaxle with appropriate fluid to proper level. See LUBRICATION  .
scientia non olet · About LEMON Manuals