LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1917 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Replacement (With Electronic Power Steering) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Turning Ignition Lock Cylinder To RUN Position
    GM874786Courtesy of GENERAL MOTORS CORP.
  1. Position the ignition lock cylinder in the run position and insert it into the ignition and start switch housing.
  2. Rotate the ignition lock cylinder in the ignition and start switch housing and verify proper rotation.
  3. Install the windshield wiper and washer switch. Refer to Windshield Wiper and Washer Switch Replacement .
scientia non olet · About LEMON Manuals