LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1916 (Instrument Panel System Displays & Gauges) >> Diagnostic Information and Procedures >> DTC P2068 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the secondary fuel level sensor.
  2. Ignition OFF, test for less than 1 ohm between the low reference circuit terminal 3 and ground.
    • If greater than the specified range, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, install a 3A fused jumper wire between the signal circuit terminal 4 and the low reference circuit terminal 3. Verify the scan tool Fuel Tank Level Remaining parameter is greater than 98 percent.
    • If less than the specified range, test the signal circuit terminal for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, perform the fuel level sensor component test before replacing the secondary fuel level sensor.
scientia non olet · About LEMON Manuals