LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1914 (Automatic Transmission - 6T75 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Transmission Fluid Cooler Pipe Connector Replacement - Radiator >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the new O-ring seals for cracks, cuts or damage. Replace if necessary.
    2. Fig 1: View Of Oil Cooler Fitting At Radiator
    GM1443001Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.
  2. Install the oil cooler fitting to the radiator and tighten to 38 N.m (28 lb ft).
  3. Install the transaxle oil cooler hoses to the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  4. Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill Without HP5) or Cooling System Draining and Filling (GE 47716 Fill Without HP5) .
  5. Adjust the transmission fluid level.
  6. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals