LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1913 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Vehicle Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: VSS Electrical Harness Retainer
    GM1878229Courtesy of GENERAL MOTORS CORP.
  2. Remove the vehicle speed sensor (VSS) electrical connector (1) from the VSS.
  3. Remove the VSS electrical harness retainer (2) from the VSS.
    4. Fig 2: Removing/Installing Vehicle Speed Sensor
    GM1548949Courtesy of GENERAL MOTORS CORP.
  4. Remove the retaining stud and the VSS. Pull straight out in order to avoid damage to the case.
scientia non olet · About LEMON Manuals