LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1913 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Transmission Fluid Cooler Pipe Fitting Seal Removal >> Removal

Transmission Fluid Cooler Pipe Fitting Seal Removal: Removal

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inserting J 45201 Into Cooler Line Seal Bore
    GM822722Courtesy of GENERAL MOTORS CORP.
  1. Insert J 45201:  seal removal collet (2) fully into the cooler line seal bore.
  2. Insert the forcing screw piece of the J 45201:  seal removal (1) into J 45201:  seal removal (2) and tighten.
    3. Fig 2: Removing Cooler Line Seal With J 45201
    GM822724Courtesy of GENERAL MOTORS CORP.
  3. Thread the J 45201:  seal removal collar (2) onto J 45201:  seal removal (3) and tighten until the tool has removed the seal.
  4. Use a pair of pliers to remove the cooler line seal from J 45201:  seal removal.
scientia non olet · About LEMON Manuals