LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1913 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Side Cover/Gaskets, Disassemble, Assemble, Install >> Install

Side Cover/Gaskets, Disassemble, Assemble, Install: Install

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Components On Side Cover
    GM20822Courtesy of GENERAL MOTORS CORP.
  1. Remove the side cover gaskets (5 and 6) and the thrust washer (7) from the side cover (1).
    2. Fig 2: View Of Side Cover Axle Seal
    GM20325Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not damage the case bore when removing the axle seal.
  2. Remove the side cover axle seal (2). Use the handle end of a hammer.
    3. Fig 3: Locating Components On Side Cover
    GM20822Courtesy of GENERAL MOTORS CORP.
  3. Inspect the side cover for cracks or damage to the seal grooves and mounting bosses.
  4. Inspect the side cover seals for damage. The side cover seals are reusable if not damaged.
  5. Thoroughly clean the side cover and the side cover seals.
  6. Clean and dry the seal grooves and the axle seal bore.
  7. Install the side cover gaskets (5 and 6) into the grooves on the side cover (1).
  8. Retain the seals with J 36850:  lubricant or equivalent.
  9. Install the side cover to drive sprocket thrust washer (7) onto the side cover.
  10. Retain the thrust washer with J 36850:  lubricant or equivalent.
    11. Fig 4: View Of Side Cover Assembly Bolts And Studs
    GM474273Courtesy of GENERAL MOTORS CORP.
  11. Install the side cover assembly onto the transmission case.
  12. Install the 11 side cover bolts (3) or studs (4) (model dependent).
    13. Fig 5: Identifying Side Cover Bolts And Stud
    GM474274Courtesy of GENERAL MOTORS CORP.
  13. Refer to the graphic in order to find the correct installation points of the bolts and the stud.
    14. Fig 6: Identifying Side Cover Bolts And Stud
    GM58705Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  14. Hand start the bolts. Tighten the side cover bolts and stud to 28 N.m (22 lb ft).
scientia non olet · About LEMON Manuals