Drive Sprocket Support Installation

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inspecting Converter Seal Drain Holes For Blockage

Courtesy of GENERAL MOTORS CORP.

Inspect the drive sprocket support (43) for damage to the stator shaft splines, the journals, the bushings, and the roller bearing.
Inspect the converter seal drain holes for blockage.

Fig 2: Locating Drive Sprocket Support

Courtesy of GENERAL MOTORS CORP.

Install the drive sprocket support (43) into the bell housing of the transmission case.
Install the six drive sprocket support bolts (53) into the drive sprocket support (43).

CAUTION: Refer to Fastener Caution .

Hand start the bolts. Tighten the bolts to 12 N.m (9 lb ft).