LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1910 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Liftgate Adjustment

Liftgate Adjustment

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Liftgate Latch Striker
    GM928950Courtesy of GENERAL MOTORS CORP.
  1. Note the original position of the liftgate latch striker.
  2. Remove the striker.
  3. Loosen the hinge-to-roof panel bolts for forward or rearward adjustments.
  4. If Adjusting hinge to roof panel Bolts. Lower Rear And Headliner if as needed.
  5. Loosen the liftgate-to-hinge bolts for up and down adjustment.
  6. Move the liftgate within the liftgate opening to achieve the best alignment and operation.
  7. Install striker to approximately the proper position.
  8. Adjust the striker to achieve the best operation and alignment of the liftgate.
  9. Inspect the seals for proper engagement.
    10. CAUTION: Refer to Fastener Caution .
  10. Tighten the bolts when the proper adjustment is achieved.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals