Hood Rear Outer Seal Replacement

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Hood Rear Outer Seal

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Hood Rear Outer Seal Procedure Clean the area where the seal will be mounted. Use a suitable solvent with a mixture of 50 percent isopropyl alcohol and 50 percent water by volume, or high-flash naphtha. Warm the hood panel using J 25070 Heat Gun, to a minimum, prior to the hood rear outer seal installation. Do NOT touch the adhesive surface when tape is removed. Peel the tape liner off and install the outer rear hood seal. Special Tools: J 25070 Heat Gun

Callout

Component Name

Hood Rear Outer Seal

Procedure

Clean the area where the seal will be mounted. Use a suitable solvent with a mixture of 50 percent isopropyl alcohol and 50 percent water by volume, or high-flash naphtha.
Warm the hood panel using J 25070 Heat Gun, to a minimum, prior to the hood rear outer seal installation.
Do NOT touch the adhesive surface when tape is removed. Peel the tape liner off and install the outer rear hood seal.

Special Tools:
J 25070 Heat Gun