LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1909 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning Compressor Oil Balancing (With HP5) >> Draining Procedure

Draining Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Drain and measure as much of the refrigerant oil as possible from the removed compressor.
  1. Drain the oil from both the suction and discharge ports of the removed compressor into a clean, graduated container.
  2. Fig 1: Draining Oil From Both Suction And Discharge Ports Of Compressor
    GM2076863Courtesy of GENERAL MOTORS CORP.
  3. Measure and record the amount of oil drained from the removed compressor. This measurement will be used during installation of the replacement compressor.

    30ml (1oz) of POE refrigerant oil will remain in the compressor after draining. This amount should be considered when calculating the amount of oil needed to replenish the system.

  4. NOTE: During the oil removal procedure, the condition of the oil should be evaluated. Compressor oil never breaks down unless something is wrong with the compressor or air conditioning (A/C) system. If one or more of the following conditions exist, replace the compressor and receiver dehydrator.
  5. Inspect oil drained from removed compressor. Refer to Air Conditioning Compressor Oil Diagnosis 
  6. Properly discard the used refrigerant oil.