LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1898 (Exterior Trim System) >> Repair Instructions >> Rear Door Frame Applique Replacement

Rear Door Frame Applique Replacement

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Door Frame Applique
GM1865496Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Rear Side Door Frame Applique Screw (Qty: 2)
CAUTION: Refer to Fastener Caution .

Procedure: 
Remove the rear inside door upper trim applique, pull rearward to release.

Tighten:  1.5 N.m (13 lb in)

2 Rear Side Door Frame Applique
3 Rear Side Door Front Frame Applique Screw (Qty: 4)

Procedure

  1. Loosen the front edge of the primary weatherstrip to expose the screws.
  2. Place the rear door window in the full down position.

Tip:  Apply masking tape to the door frame and applique.

Tighten:  1.5 N.m (13 lb in)

4 Rear Side Door Front Frame Applique
Tip:  Pull the applique up and away from the outer seal weatherstrip.