Front and Rear Side Door Opening Frame Reveal Molding Replacement

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front And Rear Side Door Opening Frame Reveal Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Open the front door on the side the front and rear side door opening frame reveal molding assembly is being removed from. Remove the front and rear side door opening frame reveal molding lower screw. Working from front to rear, release the integral retainers securing the reveal molding to the body.
1	Front and Rear Side Door Opening Frame Reveal Molding Screw CAUTION: Refer to Fastener Caution . Tighten: 1.5 N.m (13 lb in)
2	Front and Rear Side Door Opening Frame Reveal Molding Retainer (Qty: 19) Tip: Inspect and replace any plastic retainers nuts that are damaged.
3	Front and Rear Side Door Opening Frame Reveal Molding Assembly Procedure Upon assembly of the front and rear side door opening frame reveal molding to the body, insert the locating boss at the rear edge of the molding to the front top side of the body, near the rear quarter window. Align the retainers from the rear edge working towards the front. Apply palm pressure from the rear retainer to the front retainer up to the front fender screw location. Install the screw.