LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1883 (Transfer Case - MJ8) >> Repair Instructions >> Transfer Case Fluid Drain and Fill >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Drain Plug & Gasket
    GM1227168Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the drain plug and gasket.

    Tighten:  Tighten the drain plug to 44 N.m (33 lb ft).

    2. Fig 2: Transfer Case Check Plug
    GM1227157Courtesy of GENERAL MOTORS CORP.
  2. Fill the transfer case with synthetic gear oil GM P/N 12378261. Refer to Approximate Fluid Capacities .
  3. Fill the transfer case to the bottom of the oil fill plug hole.
  4. Install the oil fill plug and gasket.

    Tighten:  Tighten the oil fill plug to 44 N.m (33 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals