LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1882 (Manual Transmission Clutch System) >> Repair Instructions >> Hydraulic Clutch Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
  2. Remove the battery cover.
  3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (2.2L (L61) and 3.5L (L66)) or Battery Negative Cable Disconnection and Connection (2.4L (LAT)) .
  4. Remove the battery. Refer to Battery Replacement (2.2L (L61) and 3.5L (L66)) or Battery Replacement (2.4L (LAT)) .
  5. Loosen the battery tray bracket screw and remove the bracket.
  6. On antilock brake system (ABS) models, remove the electronic brake traction control module (EBTCM) bracket fasteners.
    7. Fig 1: Pressure Line & Clutch Actuator Cylinder
    GM1145224Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice .
  7. Place a shop towel under the clutch master cylinder in order to catch any fluid loss.
  8. Disconnect the clutch master cylinder line from the transaxle by removing the C-clip.
  9. Drain the clutch fluid into a suitable container.
  10. Remove the top transaxle mount retaining bolt.
  11. Disconnect the clutch line from the clutch master cylinder.
    12. Fig 2: Clutch Pedal Retainer, Nuts & Bolts
    GM1145261Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not damage the brake lines.
  12. Remove the clutch hydraulic line.
scientia non olet · About LEMON Manuals