Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Shoulder Belt Height Adjuster

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

IMPORTANT: Apply Permatex® 24200 on all restraint fasteners prior to installation.

Install the shoulder belt height adjuster with the fasteners.
Tighten: Tighten the fasteners to 40 N.m (30 lb ft).
Install the center pillar upper garnish molding. Refer to Center Pillar Lower Garnish Molding Replacement .
Operate the shoulder belt to ensure proper installation.