Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear seat assembly. Refer to Rear Seat Replacement .

Fig 1: Removing/Installing Cargo Hooks

Courtesy of GENERAL MOTORS CORP.

Remove the cargo hooks.

Fig 2: Removing/Installing Fasteners From The Load Floor Storage Bin

Courtesy of GENERAL MOTORS CORP.

On the driver side, remove the load floor storage bin.

Fig 3: Pushing Locks Inward & Outward

Courtesy of GENERAL MOTORS CORP.

Remove the rear load floor. If the vehicle is equipped with a lock lever, move the lever inboard and lift up on the load floor.

Fig 4: Disconnecting Accessory Wire Harness

Courtesy of GENERAL MOTORS CORP.

Remove the rear wheel quarter trim panel by pulling at the attaching clip locations.
On the driver side, disconnect the auxiliary plug wire harness connection.

Fig 5: Shoulder Belt Fastener

Courtesy of GENERAL MOTORS CORP.

Remove the shoulder belt fastener at the floor.

Fig 6: Retractor Fastener

Courtesy of GENERAL MOTORS CORP.

Remove the retractor fastener and remove the retractor.

Fig 7: View Of Lock Pillar Upper Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Unsnap the upper fastener cover and remove the shoulder belt upper fastener. Remove the shoulder belt assembly.