Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Shoulder Belt Quick Disconnect Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

IMPORTANT: Apply Permatex® 24200 on all restraint fasteners prior to installation.

Install the shoulder belt quick disconnect.
Tighten: Tighten the fasteners to 50 N.m (37 lb ft).

Fig 2: View Of Seat Cushion Outer Trim Panel - Front Seat (4-Way)

Courtesy of GENERAL MOTORS CORP.

Install the side trim with the fasteners.
Tighten: Tighten the fasteners to 2.5 N.m (22 lb in).

Fig 3: View Of Front Seat Back Recliner Trim Panel

Courtesy of GENERAL MOTORS CORP.

On the passenger side, install the recliner side cover with the fasteners.
Tighten: Tighten the fasteners to 2.5 N.m (22 lb in).

Fig 4: Installing Recliner Handle Trim

Courtesy of GENERAL MOTORS CORP.

On the driver side, install the recliner and seat riser covers by firmly pushing on the handle cover.
Install the front seat to the vehicle. Refer to Front Seat Replacement - Bucket .

IMPORTANT: Verify that the shoulder belt is not twisted.

Install the shoulder belt into the shoulder belt quick disconnect.