LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1877 (Engine Mechanical - 2.4L (Lat)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount To Bracket Bolts
    GM1810250Courtesy of GENERAL MOTORS CORP.
  1. Place the engine mount onto the side rail studs.
    2. NOTE: Refer to Fastener Notice .
  2. Install the engine mount to side rail nuts (1).

    Tighten:  Tighten the nuts to 100 N.m (74 lb ft).

    3. IMPORTANT: The engine mount to bracket bolts must be hand started. Do not pry the engine mount to align the holes.
  3. Install the engine mount to bracket bolts (2).
  4. Tighten the engine mount to bracket bolts in the following sequence.
    • Middle
    • Rear
    • Front

      Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  5. Remove the hydraulic floor jack from under the oil pan.
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals