LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1877 (Engine Mechanical - 2.4L (Lat)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount Bracket And Engine Bolts
    GM1810256Courtesy of GENERAL MOTORS CORP.
  1. Position the engine mount bracket to the engine.
  2. Install the engine mount bracket bolts in the following locations:
    • The long bolts in the forward and lower front holes
    • The short bolt in the upper rear hole
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the engine mount bracket bolts in the following sequence.
    1. Upper Left
    2. Lower Left
    3. Right

      Tighten:  Tighten the bolts to 100 N.m (74 lb ft).

  4. Install the engine mount. Refer to Engine Mount Replacement .
scientia non olet · About LEMON Manuals