LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1877 (Engine Mechanical - 2.4L (Lat)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Flywheel
    GM1578311Courtesy of GENERAL MOTORS CORP.
  1. Remove the transaxle. Refer to Transmission Replacement .
  2. Have an assistant install the J 38122-A  , and a breaker bar to the crankshaft balancer in order to prevent the flywheel from rotating when loosening the flywheel bolts.
    3. IMPORTANT: It may be necessary to remove the chamfer (bevel) from the edge of an 18 mm socket in order to get full engagement on the thin-headed flywheel bolts.
  3. Loosen, remove and discard the flywheel bolts.
    4. IMPORTANT: Do not orientate the flywheel to the crankshaft. It is balanced separately from the engine.
  4. Remove the flywheel.
  5. Clean the thread adhesive from the flywheel bolt holes. Use a nylon bristle brush to clean the holes in the crankshaft.
scientia non olet · About LEMON Manuals