LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1877 (Engine Mechanical - 2.4L (Lat)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drive Belt Tensioner, Drive Belt Tensioner Spring And Mounting Bolts
    GM1809414Courtesy of GENERAL MOTORS CORP.
    CAUTION: To avoid personal injury, only remove the tensioner shipping clip when the tensioner is properly mounted to the engine and the accessory drive belt is in place and properly routed.
  1. Position the drive belt tensioner (1).
    2. NOTE: Refer to Fastener Notice .
  2. Install the drive belt tensioner bolts (2).

    Tighten:  Tighten the bolts to 22 N.m (16 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
  4. Remove the tensioner shipping clip with a suitable pry bar and discard.
scientia non olet · About LEMON Manuals