LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1877 (Engine Mechanical - 2.4L (Lat)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Holding Balancer Using Special Tool
    GM1820840Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive belt. Refer to Drive Belt Replacement .
  2. Remove the engine splash shield. Refer to Engine Splash Shield Replacement .
  3. Install the J 38122-A  (1), and a breaker bar to the balancer in order to prevent the balancer from rotating when loosening the balancer bolt.
  4. Remove the J 38122-A  (1) and breaker bar.
    5. Fig 2: Crankshaft Balancer And Bolt
    GM1811400Courtesy of GENERAL MOTORS CORP.
  5. Remove and discard the crankshaft balancer bolt.
  6. Remove the crankshaft balancer.
scientia non olet · About LEMON Manuals