LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1877 (Engine Mechanical - 2.4L (Lat)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Balancer And Bolt
    GM1811400Courtesy of GENERAL MOTORS CORP.
  1. Position the crankshaft balancer.
  2. Install a NEW crankshaft balancer bolt.
    3. Fig 2: Holding Balancer Using Special Tool
    GM1820840Courtesy of GENERAL MOTORS CORP.
  3. Install the J 38122-A  (1), and a breaker bar to the balancer in order to prevent the balancer from rotating while tightening the bolt.
    4. NOTE: Refer to Fastener Notice .
  4. Tighten the crankshaft balancer bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft) plus an additional 125 degrees using the J 45059  .

  5. Install the engine splash shield. Refer to Engine Splash Shield Replacement .
  6. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals