LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1877 (Engine Mechanical - 2.4L (Lat)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Camshaft Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Wiring Harness Electrical Connectors
    GM1811485Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connectors (2, 3) from the intake and exhaust camshaft position actuator solenoid valves.
  3. Remove the ignition coils. Refer to Ignition Coil Replacement .
  4. Remove the engine harness clips (4) from the cover.
  5. Reposition the engine wiring harness out of the way.
    6. Fig 2: Fuel Feed Line Retainers
    GM1647977Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel feed line retainers (1, 2) from the engine brackets.
    7. Fig 3: Camshaft Cover And Bolts
    GM1578306Courtesy of GENERAL MOTORS CORP.
  7. Remove the camshaft cover bolts.
  8. Remove the camshaft cover.
scientia non olet · About LEMON Manuals